CHAPTER 5. Analog Voice Port
How to Configure Analog E & M Voice Port
To set up each parameter of basic analog E & M voice port, follow the next
procedures.
Configuration Steps
configure terminal
−
voice-port
−
dial-peer voice pots
−
exit
−
Detailed Steps
Step
1
2
3
4
5
6
7
484
Command
configure terminal
Example)
# configure terminal
voice-port
slot/subslot/port
shutdown
signal { wink-start |
immediate-start |
delay-dial }
operation {2-wire | 4-
wire}
dial-type {dtmf|mf}
locale locale
Purpose
Enters global configuration mode.
Enter voice port Configuration Mode
slot - Specifies the number of the router slot where
the voice module in installed
subslot - Specifies the number of subslot in the slot
port - Indicates the voice port
Change status of voice port to shutdown
This command enables Direct Inward Dialing on the
voice port
immediate - if the voice port must use the
immediate start protocol
wink-start - if the voice port must use the wink-start
protocol
delay-dial - if the voice port must use the delay
start protocol
Specifies the number of wires used for voice
transmission at this interface(the audio path only,
not the signaling path)
Specifies the dialing method for outgoing calls
Selects the two-letter locale for the voice call
progress tones and other locale-specific
parameters to be used on this voice port
The Default is us
ex) locale us
© SAMSUNG Electronics Co., Ltd.