Samsung Ubigate iBG2016 Configuration Manual page 164

CHAPTER 7. MultiCast Protocols
PIM Configuration Examples
This section shows examples of how the PIM commands are used.
The following example enters the BSR mode and sets Ethernet 1/0 as the BSR
interface.
Router/configure# ip multicast-routing
Router/configure# ip pim bsr-candidate ethernet1/0
To set the hash mask length for Rendezvous Point selection to 24 and set the
priority for candidate bootstratp router to 45, enter:
Router/configure# ip pim bsr-candidate ethernet1/0
To enter the candidate Rendezvous Point interface, enter:
Router/configure#ip pim rp-candidate ethernet1/0
To set the group IP address for CRP advertisements to 224.1.1.0 using the
group-list ACL, enter:
Router/configure#ip pim rp-candidate ethernet1/0 group-list
ACL
To set the flag at the DR to switch to the SPT on receiving the first packet
(default on), enter:
Router/configure#ip pim spt-threshold
The following example configures the Register Suppression Timeout to be 70
seconds.
Router/configure#ip pim register-suppression 70
128
© SAMSUNG Electronics Co., Ltd.