Figure 33: Mounting The Switch On The Front Posts In A Rack; Figure 34: Sliding The Rear Mounting-Blades To The Rear Of A Four-Post Rack - Juniper EX4500 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.

Figure 33: Mounting the Switch on the Front Posts in a Rack

Have a second person secure the front of the switch to the rack by using the appropriate
7.
screws for your rack.
Slide the rear mounting-blades into the front-mounting brackets. See
8.
Figure 34 on page 131.
Figure 34: Sliding the Rear Mounting-Blades to the Rear of a Four-Post
Rack
1— Front-mounting brackets
Attach the rear mounting-blades to the rear post by using the appropriate screws for
9.
your rack. Tighten the screws.
Ensure that the switch chassis is level by verifying that all the screws on the front of
10.
the rack are aligned with the screws at the back of the rack.
Connecting Earth Ground to an EX Series Switch on page 135
Connecting AC Power to an EX4500 Switch on page 141
Connecting DC Power to an EX4500 Switch on page 144
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 159
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 162
Mounting an EX4500 Switch in a Recessed Position in a Rack or Cabinet on page 132
Chapter 12: Installing the Switch
2— Rear mounting-blades
131