Advertisement
Related
Documentation
Mounting an OCX1100 Switch on Four Posts of a Rack or Cabinet
Copyright © 2017, Juniper Networks, Inc.
Attach the rubber feet to the bottom of the chassis, as shown in
3.
Turn the chassis right side up on the desk or the level surface.
4.
Figure 20: Attaching Rubber Feet to the Switch Chassis
Connecting AC Power to an OCX1100 Switch on page 80
Connecting DC Power to an OCX1100 Switch on page 82
Connecting and Configuring an OCX1100 Switch (CLI Procedure) on page 100
Clearance Requirements for Airflow and Hardware Maintenance for OCX1100 Switches
on page 37
You can mount an OCX1100 switch on four posts of a 19-in. rack or a 19-in. cabinet by
using the mounting brackets provided with the switch. (The remainder of this topic uses
rack to mean rack or cabinet.)
Before mounting the switch on four posts of a rack:
Verify that the site meets the requirements described in
for OCX1100 Switches" on page
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read
"General Safety Guidelines and Warnings" on page
to
"Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page
65).
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver (not provided)
Eight Phillips-head front rack-mounting bracket screws (provided)
Eight rack-mounting screws to secure the front rack-mounting brackets and the
rack-mounting slider brackets to the chassis (not provided)
One pair of front rack-mounting brackets (provided)
One pair of rack-mounting slider brackets (provided)
"Site Preparation Checklist
31.
137, with particular attention
146.
"Unpacking an OCX1100 Switch" on
Chapter 10: Installing the Switch
Figure 20 on page
71.
71
Advertisement
Chapters
