Connect A Cr 600 Check Reader; Cr 600 Check Reader Connection - VeriFone Omni 3200 Reference Manual

Omni 3200 Reference Manual

Connect a CR 600 Check Reader

12
Warning: Check readers may require a separate power source.
Before you connect a check reader, or a similar device, to the Omni
3200 terminal, be sure the device is not connected to a power source.
If necessary, disconnect the power pack cable from the device.
To connect a CR 600 check reader (see Figure 11):
1. If the cable is not already connected to the check reader, insert the
small modular plug on one end of the cable into the modular jack
on the check reader.
2. Insert the larger RJ45-type connector on the other end of the
cable into the 'RS232' serial port on the back panel of the Omni
3200 terminal.
Figure 11 CR 600 Check Reader Connection
When you have completed the next step of the installation procedure,
"Step 6: Connect the Terminal Power Pack," you may then connect
the check reader to a power source.
Step 5: Connect Optional Device(s)