VeriFone Omni 3200 Reference Manual page 112

Omni 3200 Reference Manual
Table 24 Operating System Download by Telephone
Display
8. 1–SERL 2–MODEM
9. BAUD RATE 0/2/3
10.TELEPHONE NUMBER
11.MODEM INIT STRG
96
This message is displayed to let you select a serial port
or a modem port for the download.
To perform an Omni 3200 download by telephone,
press [2] to select the internal modem, DEV_MODEM,
as the terminal's COM port for the data transfer.
NOTE: It is also possible to use the 'RS232' serial port
(sync/async) to perform a direct operating system
download. To select this option, press [1]. If you select
the serial option, the message ERASING FLASH is
displayed, followed by the message UNIT RECEIVE.
The terminal then waits for the serial data transfer to be
initiated from the download computer. To use this
option, a serial cable connection between the download
computer and the terminal is required.
This prompt is displayed when you select [2] in Step 8,
and if the baud rate selection has not been entered in the
CONFIG.SYS file. For ZONTALK, the key for this
record is *OR. The default baud rate is *OR=3, or 2400
baud. (The '0' value is for 300 baud and the '2' value is
for 1200 baud.)
Select [3] and press [FUNC/ENTER].
This prompt is displayed if the telephone number of the
download computer has not been entered in the
terminal's CONFIG.SYS file. For ZONTALK, the key
for this record is *OP.
Key in the complete dial-up telephone number for the
download computer. Do not use hyphens or other
special characters in the number. Press [FUNC/
ENTER] to store the value in CONFIG.SYS and to
continue.
This prompt is displayed if the modem initialization
string has not been entered in the CONFIG.SYS file.
The key for this record is *MI. If required, enter the
initialization string and press [FUNC/ENTER] to store
the value in CONFIG.SYS.
Action
Operating System Downloads