Change Password - VeriFone Omni 3200 Reference Manual

Appendix A. System Messages
AGAIN
The terminal is requesting that you verify the new System Password
you just entered. Re-enter the password and press [FUNC/ENTER].
BAD EPROM
This error message indicates that a checksum error occurred in the
terminal's flash EPROM memory. If the error message persists,
contact your local VeriFone representative for assistance.
BAD LRC
This error message is displayed during the card reader test if the
terminal detects a bad LRC (Longitudinal Redundancy Check) in the
magnetic stripe card data. If this occurs, try the test again with a
different card. If the message persists, contact your local VeriFone
representative for assistance.
BAD PARITY
This error message appears during the magnetic stripe card reader test
if the terminal detects a parity error. If this occurs, try the test again
with a different card. If the message persists, contact your local
VeriFone representative for assistance.
BUSY
The BUSY message is displayed if your terminal attempts to establish
a dial-up telephone connection with a remote computer, and the line is
currently in use. Try again later.
CHANGE DATE/TIME
This prompt appears briefly when you press [5] while in the System
Mode. The terminal then displays YYMMDD (year, month, date).
Enter the current date and press [FUNC/ENTER]. The prompt
HHMMSS (hours, minutes, seconds) is then displayed. Enter the
current time and press [FUNC/ENTER].

CHANGE PASSWORD

This prompt indicates that you requested a password change. Wait for
the next prompt to appear and continue the password entry procedure.
A-3