Initiating a Remote Diagnostics Session
Table 26 Remote Diagnostics Over a Telephone Line
Display
1. SYSTEM= (Firmware ID)
2. REMOTE DIAG
(or)
*T=
Performing Remote Diagnostics
The procedure described in Table 26 below explains how to initiate a
remote diagnostics session from an Omni 3200 terminal over a
telephone line connection. As in previous procedure descriptions, it
starts from the System Prompt (displayed when the terminal is in
System Mode).
To initiate a remote diagnostics session, press [8].
The message REMOTE DIAG is displayed briefly.
If no telephone number is stored in the *T= record, the
*T= prompt appears asking you to enter this number
into the CONFIG.SYS file. To do this, you simply key
in the value from the core keypad and press [FUNC/
ENTER].
If the telephone number of the remote diagnostic
computer has already been stored in the CONFIG.SYS
file, the terminal automatically starts the dial-up
procedure.
Remote Diagnostics and Debugging
Action
107