Entering System Mode
Table 4
Enter System Mode
Display
1. (Application Prompt)
(or)
DOWNLOAD NEEDED
2. SYSTEM PASSWORD?
Entering System Mode
Text presented in the Action column of a procedure description:
•
Describes the current step and context of the procedure,
•
Indicates the entries you must enter using the core keypad in
response to a currently displayed prompt or message,
•
Provides additional explanations or information about the steps of
the particular System Mode function.
Note: Entering and leaving System Mode restarts the terminal
application (assuming that an application has already been
downloaded into the terminal's memory) and terminates any
transaction that has not been completely processed.
To enter System Mode after you have connected the Omni 3200
terminal to a power source, follow the procedure described in Table 4.
If an Application Prompt is displayed, press [FUNC/
ENTER] and [7] simultaneously to enter System Mode.
If the system message DOWNLOAD NEEDED is
displayed, press [CLEAR] to enter System Mode.
If an Application Prompt was displayed in Step 1 (that
is, if an application has already been downloaded into
the terminal memory), key in the System Password and
press [FUNC/ENTER].
The default password, which is pre-set at the factory, is
[1] [ALPHA] [ALPHA] [6] [6] [8] [3] [1].
NOTE: Until an application has been downloaded into
the terminal memory (that is, if the DOWNLOAD
NEEDED message is displayed on your terminal), no
password is required to enter System Mode.
Performing System Mode Operations
Action
35