VeriFone Omni 3200 Reference Manual page 92

Omni 3200 Reference Manual
76
Note: NOTE: If you do not know the correct values for *ZP, *ZT,
and *ZA, contact your local VeriFone representative for information
or instructions.
• If a baud rate other than 2400 bps is required for the application
download by telephone, you can optionally assign a value to the
*ZR record stored in CONFIG.SYS. Available baud rates are as
follows:
Parameter
No value
*ZR= 0
*ZR= 2
*ZR= 3
Note: The following procedure description assumes that the
ZONTALK setup and configuration requirements described above
have been completed and confirmed to be correct on the download
computer and on the Omni 3200 terminal.
Note: For details about the setup requirements and download
procedures for VeriTalk, please refer to the VeriTalk Enterprise
System 1.3 User's Guide, VeriFone Part Number 52077-02..
Starting the Download by Telephone Procedure
When you have set up the download computer and terminal, as
describe above, you can start the download procedure, as described in
Table 21 below.
Baud Rate
2400
300
1200
2400
Application Downloads