Performing A Terminal-To-Terminal Operating System Upload; Terminal-To-Terminal Operating System Upload - VeriFone Omni 3200 Reference Manual

Performing a Terminal-to-Terminal Operating
System Upload
Table 25 Terminal-to-Terminal Operating System Upload
Display
1a. Sending Terminal:
(Application Prompt)
(or)
DOWNLOAD NEEDED
1b. Receiving Terminal:
(Application Prompt)
(or)
DOWNLOAD NEEDED
2a. Sending Terminal:
ENTER PASSWORD
Operating System Downloads
The procedure described in Table 25 below tells you how to transfer a
complete TXO operating system version from one Omni 3200
terminal to another.
To perform this upload, the sending and receiving terminals are
connected at their respective RS232 ports by a serial cable, as
described at the beginning of this section.
For terminal-to-terminal operating system uploads, the sending and
receiving terminal to not necessarily have to have the same
bootloader version and SRAM size, although this is recommended.
Note: The following procedure requires that you perform actions on
both the sending and receiving terminal. For this reason, information
in the 'Display' and 'Action' columns is presented twice, and steps
are numbered accordingly as 1a, 1b, 2a, 2b, and so on.
Disconnect the power supply from the terminal.
Press and hold down the [CLEAR] key and reconnect
the power supply to the power port on the terminal's
back panel.
Disconnect the power supply from the terminal.
Press and hold down the [CLEAR] key and reconnect
the power supply to the power port on the terminal's
back panel.
When the terminal beeps, release the [CLEAR] key.
The ENTER PASSWORD prompt is displayed. Key
in the System Password.
Performing Downloads
Action
99