VeriFone Omni 3200 Reference Manual page 94

Omni 3200 Reference Manual
Table 21 Application Download by Telephone (Using ZONTALK)
Display
5. DIAL (Phone number)
(or)
NO LINE
(or)
NO DIALTONE
(or)
BUSY
(or)
NO ANSWER
6. CONNECTED
----------
*---------
**--------
***-------
****------
(. . .)
**********
78
The terminal's modem starts dialing the number stored
in the *ZP record. Several different messages may be
displayed at this point to indicate the status of the dial-
up attempt:
– NO LINE is displayed if no telephone line is
plugged in to the Telco or Telset port. Check the
terminal's modem port connection.
– NO DIALTONE is displayed if the terminal could
not get a dial tone on its dial-up line. Check the
telephone line with a phone or another terminal.
– BUSY is displayed if a busy signal is received when
the number of the remote computer is dialed. Try
again later.
– NO ANSWER is displayed if the modem of the
remote computer does not answer the call from the
terminal. Check that the phone number stored in the
*ZP record is correct. Try again later.
NOTE: If the remote computer does not answer the
terminal's call within 55 seconds (U.K), 30 seconds
(U.S.) or 45 seconds (other countries), the terminal
ends the dial-up session and the modem "hangs up."
When the telephone line connection between the Omni
3200 terminal and the remote download computer is
established, the CONNECTED prompt is displayed
and the download begins.
The terminal displays the progress of the download.
Each asterisk (*) displayed represents 10% of the
application being transferred. When the display shows
ten asterisks, the download is complete.
NOTE: To stop the download at any time, press
[CLEAR]. The download procedure ends and the
terminal returns to the System Prompt.
Action
Application Downloads