T - Configure Diagnostics Parameters (Debugger Only) - VeriFone Omni 3200 Reference Manual

T — Configure Diagnostics Parameters (Debugger Only)
Descriptions of Diagnostic and Debugging Commands
Command Packet Received by Terminal:
<FFh> <55h> <count> S <CRC1> <CRC2>
Response Packet Sent by Terminal:
<FFh> <55h> <count> S <CRC1> <CRC2>
The T command sets the diagnostics status byte, which is also
reported as part of the L and I command response packet.
Bit Input/Output
Bit 0 Output
Bit 7 Input
Command Packet Received by Terminal:
<FFh> <55h> <count> T <status byte> <CRC1> <CRC2>
Response Packet Sent by Terminal:
<FFh> <55h> <count> T <CRC1> <CRC2>
Remote Diagnostics and Debugging
Setting Description
1 = If the source file name has
changed because the previous
F command was issued
0 = Otherwise.
1 = Set stepping on EM
instructions
0 = Set stepping on source lines.
125