VeriFone Omni 3200 Reference Manual page 109

Operating System Downloads
Setting Up the Download Computer (VeriTalk)
To set up the download computer to perform a VeriTalk operating
system download by telephone, follow these general guidelines:
1. Set up the Family and Application configuration on the download
computer using the VeriTalk user interface.
2. Invoke the Family configuration and check if the Omni 3200 is
listed. If not, enter this device and fill in the respective fields.
3. Invoke the Application configuration and add the name of the
application (or in this case, the operating system) you want to
download to the corresponding Family selection (Omni 3200).
4. Switch to the Download Info tab on the Configuration screen and
specify the files to be downloaded for that application. (This step
is equivalent to defining the ZONTALK <terminal>.TDD file.)
For selective file downloads, you can also specify a KEY value.
5. Switch to the Parameter Info tab on the Configuration screen and
specify the details of the memory locations, such as valid ranges,
allowed characters, and so on. (This step is equivalent to defining
the ZONTALK <terminal>.TDF file.)
6. Invoke the Relation Editor and add Terminal(s) for the download.
After you add a terminal, specify (configure) the parameters to be
downloaded for that terminal. You can also use the KEY directive
to select specific files for download.
Note: You can import existing .DLD and/or .TDF files into VeriTalk
using the Import utility from the VeriTalk user interface. You can also
import files that contain useful configuration and parameter data.
Note: For details about the setup requirements and download
procedures for VeriTalk, please refer to the VeriTalk Enterprise
System 1.3 User's Guide, VeriFone Part Number 52077-02.
Performing Downloads
93