VeriFone Omni 3200 Reference Manual page 122

Omni 3200 Reference Manual
106
Setting Up the Terminal
Before you can perform a remote diagnostics session over a telephone
line connection, the following requirements must be met:
• The Omni 3200 terminal must be connected to a dial-up
telephone line.
• The remote diagnostic computer must be set up and ready to
receive a telephone request from the Omni 3200 terminal.
• The telephone number of the remote diagnostic computer number
must be stored in a keyed record in the terminal's CONFIG.SYS
file under the record key, *T.
Note: If the *T record is not present in the CONFIG.SYS file when
you start remote diagnostics, you will be prompted to enter the
telephone number during the procedure.
• To select a specific baud rate for the diagnostics session, you can
include a *RDR record in the CONFIG.SYS file of the terminal
to be diagnosed. The *RDR record is optional. If the remote
computer does not detect the *RDR record when it dials up the
terminal, it uses the default value of 2400 baud (*RDR= 3).
Possible values for *RDR include the following:
00 = 300
01 = 600
02 = 1200
03 = 2400
04 = 4800
05 = 9600
06 = 19200
Note: Because *RDR is an optional value, you will not be prompted
to enter this keyed record during the diagnostics procedure described
in Table 26 below.
Performing Remote Diagnostics