Initiate Remote Diagnostics - VeriFone Omni 3200 Reference Manual

Omni 3200 Reference Manual
Table 14 Edit a Keyed File
Display
5. RECALL?
6. SYSTEM= (Firmware ID)

[8]: Initiate Remote Diagnostics

50
When you are adding, deleting, or modifying variables,
press [CLEAR] to return to the RECALL? prompt.
NOTE: If you are editing a record, and if you press
[CLEAR] before you press [FUNC/ENTER], the
updated value is not saved.
When the RECALL? prompt is displayed, press
[CLEAR] to exit the keyed file editor and return to the
System Prompt.
At the System Prompt, you can select another System
Mode function, or press [CLEAR] again to exit System
Mode and restart the terminal application.
The Keyed File Character Set
The keyed file character set consists of 95 ASCII characters from 00h
to 5Fh (hexadecimal), or 0 to 95 (decimal). Characters outside this
range should not be used and cannot be entered using the keyed file
editor.
Note: For a complete list of the ASCII characters supported by the
Omni 3200, as well as their decimal and hexadecimal equivalents,
please refer to Appendix B.
Press [8] in System Mode to initiate a remote diagnostics session
between the Omni 3200 terminal and a remote host computer over a
telephone line.
Note: For detailed information about performing remote
diagnostics, please refer to the section, "Performing Downloads."
Action
[8]: Initiate Remote Diagnostics