2. Insert the 9-pin receptacle end of the serial cable into the modem connector on the
3. Insert the 25-pin plug connector into the modem RS-232 data communications
Connecting a network management station to the SF/CPU
Use the management port to connect the switch to a network management station for out-of-
band management using a Web browser or Device Manager.
Procedure steps
1. Connect an Ethernet cable to the network management station.
2. Connect the other end of the cable to the RJ-45 jack on the 8692SF/CPU or 8895SF/
Connecting and managing cables
Use cable management brackets to keep groups of cable clusters fastened and out of the way,
but accessible for maintenance. To facilitate card installation and removal, connect, label, and
bundle the cables for each module together.
Procedure steps
1. Connect the appropriate cable to the module.
2. Route the cable up to the appropriate cable management bracket and channel as
Installation — Modules
Setting
Data bits
Stop bits
Parity
8692SF/CPU or 8895SF/CPU module.
port.
For 10 Mbps connections, you can use Category 3, 4, or 5 copper unshielded
twisted pair (Ethernet) cable. Use only Category 5 UTP cable to connect ports that
operate at 100 Mbps.
CPU module.
shown in the following figures.
Connecting a network management station to the SF/CPU
8
1
None
Value
October 2014
97