Enabling And Disabling Mld Querier-Forwarding; Enabling The Mld Querier-Forwarding; Disabling The Mld Querier-Forwarding; Configuring And Restoring The Mld Version - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring IP Multicast Switching

Enabling and Disabling MLD Querier-forwarding

By default, MLD querier-forwarding is disabled.The following subsections describe how to enable and
disable MLD querier-forwarding by using the

Enabling the MLD Querier-forwarding

You can enable the MLD querier-forwarding by entering
the enable keyword. For example, to enable the MLD querier-forwarding on the system if no VLAN is
specified, you would enter:
-> ipv6 multicast querier-forwarding enable
You can also enable the MLD querier-forwarding on the specified VLAN by entering:
-> ipv6 multicast vlan 2 querier-forwarding enable

Disabling the MLD Querier-forwarding

You can disable the MLD querier-forwarding by entering
by the disable keyword. For example, to disable the MLD querier-forwarding on the system if no VLAN
is specified, you would enter:
-> ipv6 multicast querier-forwarding disable
Or, as an alternative, enter:
-> ipv6 multicast querier-forwarding
To restore the MLD querier-forwarding to its default setting (i.e., disabled).
You can also disable the MLD querier-forwarding on the specified VLAN by entering:
-> ipv6 multicast vlan 2 querier-forwarding disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 querier-forwarding
To restore the MLD querier-forwarding to its default setting (i.e., disabled).
You can remove an MLD querier-forwarding entry on the specified VLAN and return to its default behav-
ior by entering:
-> no ipv6 multicast vlan 2 querier-forwarding

Configuring and Restoring the MLD Version

By default, the version of Multicast Listener Discovery (MLD) Protocol is Version 1. The following
subsections describe how to configure the MLD version as Version 1 or Version 2 by using the
ipv6 multicast version

Configuring the MLD Version 2

To change the MLD version to Version 2 (MLDv2) on the system if no VLAN is specified, use the
ipv6 multicast version
-> ipv6 multicast version 2
OmniSwitch AOS Release 6 Network Configuration Guide
ipv6 multicast querier-forwarding
command.
command as shown below:
Configuring IPMSv6 on a Switch
ipv6 multicast querier-forwarding
ipv6 multicast querier-forwarding
September 2009
command.
followed by
followed
page 42-25