Enabling And Disabling Mld Querier-Forwarding; Configuring And Restoring The Mld Version - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring IP Multicast Switching

Enabling and Disabling MLD Querier-forwarding

By default, MLD querier-forwarding is disabled.The following subsections describe how to enable and
disable MLD querier-forwarding by using the
Enabling the MLD Querier-forwarding
You can enable the MLD querier-forwarding by entering
the enable keyword. For example, to enable the MLD querier-forwarding on the system if no VLAN or
SPB service is specified, you would enter:
-> ipv6 multicast querier-forwarding enable
You can also enable the MLD querier-forwarding on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 querier-forwarding enable
-> ipv6 multicast service 10 querier-forwarding enable
Disabling the MLD Querier-forwarding
You can disable MLD querier-forwarding by entering
the disable keyword. For example, to disable MLD querier-forwarding on the system if no VLAN or SPB
service is specified, you would enter:
-> ipv6 multicast querier-forwarding disable
Or, as an alternative, enter the following command to restore MLD querier-forwarding to its default
setting:
-> no ipv6 multicast querier-forwarding
You can also disable MLD querier-forwarding on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 querier-forwarding disable
-> ipv6 multicast service 10 querier-forwarding disable
Or, as an alternative, enter the following commands to restore MLD querier-forwarding to its default
setting:
-> no ipv6 multicast vlan 2 querier-forwarding
-> no ipv6 multicast service 10 querier-forwarding

Configuring and Restoring the MLD Version

By default, the version of Multicast Listener Discovery (MLD) Protocol is Version 1. The following
subsections describe how to configure the MLD version as Version 1 or Version 2 by using the
multicast version command.
Configuring the MLD Version 2
To change the MLD version to Version 2 (MLDv2) on the system if no VLAN or SPB service is specified,
use the ipv6 multicast version
-> ipv6 multicast version 2
OmniSwitch AOS Release 8 Network Configuration Guide
ipv6 multicast querier-forwarding
ipv6 multicast querier-forwarding
command as shown below:
December 2017
Configuring IPMSv6 on a Switch
ipv6 multicast querier-forwarding
command.
followed by
followed by
ipv6
page 25-29