Set Maintenance_Ip - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
Privileges: Administrator
(1) Syntax
- Manual setting
set ipv6 <ip address/prefix>
- Automatic setting
set ipv6 auto
(2) Options
This option automatically sets an IP address.
(3) Usage example
- Manual setting
#set ipv6 2001:db8:caaf:beef:206:29ff:fe1e:482e/48
#
- Automatic setting
Suppose the GUID (device serial number) is "123456789abcdef0".
#set ipv6 auto
2001:xxxx:xxxx:xxxx:xxxx:1234.5678.9abc.def0 /64
Are you sure to continue?[Y/N]
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
Unable to execute this command on a standby MMB.
The specified IP address is invalid.
The specified netmask is invalid.
The specified IP address is duplicated.
The specified IP address is loopback address.
2.2.21

set maintenance_ip

Remarks
Supported only for IPv4.
The set maintenance_ip command sets the IP address of the maintenance port.
The IP address, netmask, gateway address, and SMTP address have a common default setting of 0.0.0.0.
- ip address: IP address set for the maintenance port (If 0.0.0.0 is specified, the other settings are cleared.)
- subnet mask: Subnet mask of the IP address
- gateway address: Gateway
243 C122-E110-10EN