Fujitsu PRIMEQUEST 1000 Series Tool Reference page 247

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
Command
update ALL
MMB configuration and other
set active_mmb
show active_mmb
exit
help
Command termination code display
show exit_code
Firmware revision status/version check
show update_status
Network survey commands
netck traceroute
netck arptbl
netck arping
netck ifconfig
netck stat
REMCS-related commands
set maintenance_ip
show maintenance_ip
TABLE 2.3 MMB CLI commands (Operator)
Command
Power control
power off
power on
sadump
reset
nmi
Partition creation
add partition
remove partition
show partition configuration
Administrator
Permitted Batch-updates the firmware (new).
Permitted Sets the active MMB.
Permitted Displays the active MMB.
Permitted Logs out from the MMB.
Permitted Help information
Permitted Displays the termination code for the last
command executed.
Permitted Displays the batch firmware update progress.
Permitted Displays a list of network routes.
Permitted Displays the physical Ethernet address.
Permitted Displays the physical Ethernet address.
Permitted Displays the network environment setup status.
Permitted Displays a list of port numbers being used.
Permitted Sets the REMCS network.
Permitted Displays the REMCS network setting.
Operator
Turns the power off.
Turns the power on.
sadump instruction (Japanese only)
Hard Reset instruction
NMI interrupt instruction
Adds a partition component.
Removes a partition component.
Permitted Displays the partition configuration.
215
Outline
Outline
C122-E110-10EN