Fujitsu PRIMEQUEST 1000 Series Tool Reference page 252

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
Command
exit
help
Command termination code display
show exit_code
Firmware revision status/version check
show update_status
Network survey commands
netck traceroute
netck arptbl
netck arping
netck ifconfig
netck stat
REMCS-related commands
set maintenance_ip
show maintenance_ip
* A user with Partition Operator privileges can perform operations on the "Same" partition but not on the "Other"
partition.
TABLE 2.5 MMB CLI commands (User)
Command
Power control
power off
power on
sadump
reset
nmi
Partition creation
add partition
remove partition
show partition configuration
Partition Partition
Operator (*) Operator (*)
(Same (Other
partition) partition)
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
Permitted Permitted
User
Permitted
220
Outline
Logs out from the MMB.
Help information
Displays the termination code for the last
command executed.
Displays the batch firmware update progress.
Displays a list of network routes.
Displays the physical Ethernet address.
Displays the physical Ethernet address.
Displays the network environment setup status.
Displays a list of port numbers being used.
Sets the REMCS network.
Displays the REMCS network setting.
Outline
Turns the power off.
Turns the power on.
sadump instruction (Japanese only)
Hard Reset instruction
NMI interrupt instruction
Adds a partition component.
Removes a partition component.
Displays the partition configuration.
C122-E110-10EN