Netck Arping - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
(2) Options
None
(3) Usage example
# netchk arptbl
IP address HW type Flags HW address Mask Device
10.1.2.3 0x1 0x2 00:21:A1:1A:32:45 * bond0
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
The specified parameter is invalid.
(5) Processing
Only cat /proc/net/arp bond0 (management LAN) is displayed.
2.3.30

netck arping

The netck arping command displays the Ethernet physical address (MAC address) obtained from the specified IP
address.
Remarks
Supported only for IPv4.
Privileges: All
(1) Syntax
netck arping <ip>
(2) Options
None
(3) Usage example
# netck arping 10.1.2.3
ARPING to 10.1.2.3 from 10.1.2.33 via bond0
Unicast reply from 10.1.2.3 [0:21:a1:1a:32:45] 1.253ms
Sent 1 probes (1 broadcast(s))
Received 1 reply
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
The specified parameter is invalid.
274 C122-E110-10EN