Fujitsu PRIMEQUEST 1000 Series Tool Reference page 397

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 4 PSA CLI (Command Line Interface) Operations
Source IPs for PRIMECLUSTER Service:
192.168.0.0/24
192.168.1.5
Press "Y" to confirm above settings, "N" to cancel all settings
> Y
The setting was completed
4. Execute the iptables -L -n command to confirm that the configuration chain "MMLAN" exists.
Executing the setmlanfw.sh command creates the configuration chain "MMLAN," which is referenced by
the INPUT and OUTPUT chains.
Execution example
# iptables -L -n
Chain INPUT (policy DROP)
target prot opt source
MMLAN all
Chain FORWARD (policy DROP)
target prot opt source
Chain OUTPUT (policy DROP)
target prot opt source
MMLAN all
Chain MMLAN (2 references)
target prot opt source
ACCEPT udp
7000:7100
ACCEPT udp
7000:7100
ACCEPT udp
ACCEPT udp
ACCEPT udp
7000:7100
ACCEPT udp
7000:7100
ACCEPT udp
ACCEPT udp
(7) Configuration deletion procedure
To change part of the firewall configuration, such as the IP address of the management LAN interface, first delete
the configuration.
After deleting it, reconfigure the firewall.
-- 0.0.0.0/0
-- 0.0.0.0/0
-- 192.168.0.0/24
-- 192.168.0.1
-- 192.168.0.0/24
-- 192.168.0.1
-- 192.168.1.5
-- 192.168.0.1
-- 192.168.1.5
-- 192.168.0.1
destination
0.0.0.0/0
destination
destination
0.0.0.0/0
destination
192.168.0.1
192.168.0.0/24
192.168.0.1
192.168.0.0/24
192.168.0.1
192.168.1.5
192.168.0.1
192.168.1.5
365
udp dpts:
udp spts:
udp dpt:162
udp spt:162
udp dpts:
udp spts:
udp dpt:162
udp spt:162
C122-E110-10EN