Snmp Security Setting Command (Setsnmpsec) - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 4 PSA CLI (Command Line Interface) Operations
4.8

SNMP Security Setting Command (setsnmpsec)

The setsnmpsec command sets security for SNMP Service (by specifying the hosts from which to accept SNMP
packets). If the SNMP Service security setting is [Accept SNMP packets from any hosts], you need not execute
this command.
Use this command when you have changed the MMB IP address of the PSA-MMB LAN after PSA installation on
a system operating with the SNMP service security setting of [Accept SNMP packets from these hosts]. Also use
the command when you have changed the SNMP service security setting from [Accept SNMP packets from any
hosts] to [Accept SNMP packets from these hosts].
Remarks
- This command is available only in Windows.
- The user must have Administrator privileges to execute this command. If an operating system function (access
control function) is used to execute the command with privileges other than Administrator privileges, the
end status is undefined.
(1) Syntax
setsnmpsec
(2) Options
None
(3) Usage example
> setsnmpsec
(4) Output messages
- Normal end:
FJSVpsa : I 04200 Security setting for SNMP Service was completed.
- Abnormal end:
FJSVpsa : E 04201 An error occurred at the time of security setting for SNMP Service.
(5) Notes
After executing this command, restart SNMP Service.
357 C122-E110-10EN