Fujitsu PRIMERGY BX900 User Manual page 751

10.17.2.17 match ethertype
This command adds to the specified class definition a match condition based on the value of the ethertype.
The <ethertype> value is specified as one of the following keywords: appletalk, arp, ibmsna, ipv4, ipv6,
ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom ethertype value in the range of
0x0600-0xFFFF.
NOTE: This command is not available on the Broadcom 5630x platform.
Syntax
match ethertype {<keyword> | <0x0600-0xFFFF>}
<keyword> - Specifies appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast etc
<0x0600-0xFFFF> - Specifies ethertype value.
Default Setting
None
Command Mode
Class-Map Config
10.17.2.18 match source-address mac
This command adds to the specified class definition a match condition based on the source MAC address
of a packet. The <address> parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal
numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask> parameter is a layer 2 MAC
address bit mask, which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., ff:07:23:ff:fe:dc).
NOTE: This command is not available on the Broadcom 5630x platform.
Syntax
match source-address mac <address> <macmask>
<address> - Specifies any layer 2 MAC address.
<macmask> - Specifies a layer 2 MAC address bit mask.
Default Setting
None
Command Mode
Class-Map Config
2011 Fujitsu Technology Solutions
©
749