10.6.7.2
snmpinform <name> <ipaddr | ipv6Addr>
This command adds an SNMP inform name. The maximum length of the name is 64 case-sensitive
alphanumeric characters.
Syntax
snmpinform <name> <ipaddr | ipv6Addr > [version snmpv2 | version snmpv3 <auth | noauth | priv>]
no snmpinform <name> <ipaddr | ipv6Addr >
<name> - SNMP inform name (Range: up to 64 case-sensitive alphanumeric characters).
<ipaddr | ipv6Addr> - an IPv4 or IPv6 address of the inform receiver.
no - This command deletes trap receivers for a community.
Default Setting
None
Command Mode
Global Config
10.6.7.3
snmpinform ipaddr
This command changes the IP or IPv6 address of the inform receiver for the specified community name.
The maximum length of name is 64 case-sensitive alphanumeric characters.
Note: IP or IPv6 addresses in the SNMP inform receiver table must be unique for the same community
name. If you make multiple entries using the same IP address and community name, the first entry is
retained and processed. All duplicate entries are ignored.
Syntax
snmpinform ipaddr <name> <ipaddr | ipv6Addr> <new ipAddr | ipv6Addr>
<name> - SNMP inform name.
<ipaddr | ipv6Addr> - an original IPv4 or IPv6 address.
< new ipAddr | ipv6Addr> - a new IPv4 or IPv6 address.
Default Setting
None
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
541