10.4.11.2
storm-control broadcast
This command enables broadcast storm recovery mode on the selected interface. If the mode is
enabled, broadcast storm recovery with high threshold is implemented. The threshold implementation
follows bit per second (bps) and packet per second (pps) pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold rate, the switch discards the broadcast traffic until the broadcast traffic
returns to the threshold rate or less.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on the seleted interfaces.
Default Setting
Disabled
Command Mode
Interface Config
This command enables broadcast storm recovery mode on all interfaces.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on all interfaces.
Default Setting
None
Command Mode
GlobaI Config
2011 Fujitsu Technology Solutions
©
481