Fujitsu PRIMERGY BX900 User Manual page 502

10.6.1.7 ip default-gateway
This command sets the IP address of the default gateway.
Syntax
ip default-gateway <gateway>
no ip default-gateway
< gateway > - IP address of the default gateway
no - Restore the default IP address of the default gateway
The gateway of in-band and out-of-band (oob) management interface can't be set at the
i
same time. If the gateway of oob has been set, you have to remove it before you configure
the gateway of in-band management interface.
Default Setting
IP address : 0.0.0.0
Command Mode
Global Config
10.6.1.8 ip address protocol
This command specifies the network configuration protocol to be used. If you modify this value, the
change is effective immediately.
Syntax
ip address protocol {bootp | dhcp | none}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<none> - Obtains IP address by setting configuration.
Both of in-band and out-of-band management interfaces could be configured to use DHCP
i
to get the IP address from DHCP server at a time, but not simultaneously.
Default Setting
None
Command Mode
Interface-Vlan Config
2011 Fujitsu Technology Solutions
©
500