Fujitsu PRIMERGY BX900 User Manual page 181

9.2.16.4 Sampler Config
sFlow agent collects statistical packet-based sampling of switched flows and sends them to the
configured receivers. A data source configured to collect flow samples is called a sampler.
Figure : sFlow Sampler Config
Selection Criteria
Interface - sFlowDataSource for this flow sampler. This Agent will support Physical ports only.
Configurable Data
Receiver Index - The sFlow Receiver for this flow sampler. Only active receivers can be set. If a
receiver expires then all samplers associated with the receiver will also expire. Allowed range is (1 to
8 )
Sampling Rate - The statistical sampling rate for packet sampling from this source. A sampling rate
of 0 disables sampling. Allowed range is (256 to 65536, 0 for disable )
Maximum Header Size - The maximum number of bytes that should be copied from a sampled
packet. Allowed range is (20 to 256 )
Non-Configurable Data
Receiver Index - The sFlowReceiver for this sFlow sampler.
Sampling Rate - The statistical sampling rate for packet sampling from this source.
Maximum Header Size - The maximum number of bytes that should be copied from a sampled
packet.
Command Buttons
Apply - Send the updated data to the switch and cause the changes to take effect on the switch.
Delete - Delete the sampler data.
Refresh - Refresh the data on the screen with present state of data in the switch.
2011 Fujitsu Technology Solutions
©
179