Fujitsu PRIMERGY BX900 User Manual page 348

Switch ID - Displays the switch ID of the selected switch in the stack. This can be altered to
renumber the switch ID of the selected switch by admin users. This field is non-configurable for users
with read-only access.
Switch Name - Displays the identifier of the selected unit in the stack. This field is non-configurable
if this unit is presented.
Non-Configurable Data
Serial Number - Displays the unique box serial number for the switch.
Role - Displays whether the selected switch is the master or a slave.
MAC Address - The MAC address of switch units.
Hardware Management Preference - A two-byte field that indicates whether this unit is capable of
becoming the Management Unit. If the value is set to zero then the unit cannot support Management
Unit function. The higher value means that the unit is more desirable than another unit with lower
value for running the management function. The device manufacturer sets this field.
Switch Type - Identifies the hardware type of the selected unit. This is a 32-bit data field.
Current Status - Displays the status of the selected unit. The possible values are:
Ready
Not Ready
Unsupported
Code Mismatch
Mode Mismatch
Code Updating
Not Present
Switch Description - Displays a 80-byte data field used to identify the device.
Detected Code Version - Release number and version number of the code detected.
Detected Code in Flash - Displays the Release number and version number of the code stored in
flash.
Up Time - Displays the relative time since the last reboot of the switch.
Command Buttons
Apply - Update the switch with the values on the screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete - Removes the selected unit from the stack.
To be Master - Makes the selected unit to be master.
Refresh - Update the information on the page.
2011 Fujitsu Technology Solutions
©
346