10.6.11.3
oob protocol
This command specifies the oob configuration protocol to be used. If you modify this value, the change is
effective immediately.
Syntax
oob protocol {bootp | dhcp | dhcp6 | none}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IP address by setting configuration.
Default Setting
DHCP.
Command Mode
Global Config
10.6.11.4
oob protocol dhcp6 restart
This command is used to initiate a DHCPv6 client request by oob interface.
Syntax
oob protocol dhcp6 restart
Default Setting
None.
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
553