Fujitsu PRIMERGY BX900 User Manual page 101

9.2.4.2 Upload From Switch
Use this menu to upload a code, configuration or log file from the switch.
Figure : File Upload From Switch
Selection Criteria
File Type - Specify the type of file you want to upload. The available options are Script, Code, CLI
Banner, Configuration, Error Log, Buffered Log, and Trap Log. The factory default is Code.
Protocol Mode - Specify the protocol of mode to upload. The available options are FTP and TFTP.
Configurable Data
FTP/TFTP Server IPv4 Address - Enter the IPv4 address of the FTP/ TFTP server. The factory
default is 0.0.0.0
FTP/TFTP Server Host Name - Enter the Host Name of the FTP/TFTP server.
FTP/TFTP Server IPv6 Address - Enter the IPv6 address of the FTP/TFTP server.
FTP/TFTP File Path (Target) - Enter the path on the FTP/TFTP server where you want to put the file
being uploaded. You may enter up to 96 characters (including the tailing slash). The factory default is
blank.
FTP/TFTP File Name (Target) - Enter the name you want to give the file being uploaded. You may
enter up to 32 characters. The factory default is blank.
FTP/TFTP File Name (Source) - Specify the file witch you want to upload from switch.
Start File Transfer - To initiate the upload you need to check this box and then select the Apply
button.
Non-Configurable Data
The last row of the table is used to display information about the progress of the file transfer. The
screen will refresh automatically until the file transfer completes.
Command Buttons
Apply - Send the updated screen to the switch perform the file upload.
2011 Fujitsu Technology Solutions
©
99