10.17.2.14 match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4 port of
a packet using a single keyword or numeric notation or a numeric range notation.
Syntax
match srcl4port {<portkey> | <0-65535>}
<portkey> is one of the supported port name keywords (listed below).
The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp,
www. Each of these translates into its equivalent port number, which is used as both the start and end of a
port range.
To specify the match condition as a numeric value, one layer 4 port number is required. The port number is
an integer from 0 to 65535.
To specify the match condition as a range, two layer 4 port numbers are required and together they specify
a contiguous port range. Each port number is an integer from 0 to 65535, but with the added requirement
that the second number be equal to or greater than the first.
Default
None
Command Mode
Class-Map Config
2011 Fujitsu Technology Solutions
©
747