Fujitsu PRIMERGY BX900 User Manual page 591

10.6.17.12 lldp transmit-mgmt
This command uses to include transmission of the local system management address information in the
LLDP frames.
Syntax
lldp transmit-mgmt
no lldp transmit-mgmt
no - This command is used to cancel inclusion of the management information in LLDP frames.
Default Setting
None
Command Mode
Interface Config
10.6.17.13 lldp transmit-tlv
This command is used to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDP frames. Use sys-name to transmit the system name TLV. To
configure the system name, please refer to "snmp-server" command. Use sys-descto transmit the system
description TLV. Use sys-cap to transmit the system capabilities TLV. Use port-desc to transmit the port
description TLV. To configure the port description, please refer to "description" command. Use org-spec to
transmit the organization specific TLV.
Syntax
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no - This command is used to remove an optional TLV from the LLDP frames. Use the command
without parameters to remove all optional TLVs from the LLDP frame.
Default Setting
None
Command Mode
Interface Config
2011 Fujitsu Technology Solutions
©
589