Fujitsu PRIMERGY BX900 User Manual page 275

Transmit Period - This input field allows the user to configure the transmit period for the selected
port. The transmit period is the value, in seconds, of the timer used by the authenticator state
machine on the specified port to determine when to send an EAPOL EAP Request/Identity frame to
the supplicant. The transmit period must be a number in the range of 1 and 65535. The default value
is 30. Changing the value will not change the configuration until the Apply button is pressed.
Supplicant Timeout - This input field allows the user to enter the supplicant timeout for the selected
port. The supplicant timeout is the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supplicant timeout must be a value in the range
of 1 and 65535. The default value is 30. Changing the value will not change the configuration until
the Apply button is pressed.
Server Timeout - This input field allows the user to enter the server timeout for the selected port.
The server timeout is the value, in seconds, of the timer used by the authenticator on this port to
timeout the authentication server. The server timeout must be a value in the range of 1 and 65535.
The default value is 30. Changing the value will not change the configuration until the Apply button is
pressed.
Maximum Requests - This input field allows the user to enter the maximum requests for the
selected port. The maximum requests value is the maximum number of times the authenticator state
machine on this port will retransmit an EAPOL EAP Request/Identity before timing out the
supplicant. The maximum requests value must be in the range of 1 and 10. The default value is 2.
Changing the value will not change the configuration until the Apply button is pressed.
Reauthentication Period - This input field allows the user to enter the reauthentication period for
the selected port. The reauthentication period is the value, in seconds, of the timer used by the
authenticator state machine on this port to determine when reauthentication of the supplicant takes
place. The reauthentication period must be a value in the range of 1 and 65535. The default value is
3600. Changing the value will not change the configuration until the Apply button is pressed.
Command Buttons
Initialize - This button begins the initialization sequence on the selected port. This button is only
selectable if the control mode is 'auto'. If the button is not selectable, it will be grayed out. Once this
button is pressed, the action is immediate. It is not required to press the Apply button for the action to
occur.
Reauthenticate - This button begins the reauthentication sequence on the selected port. This button
is only selectable if the control mode is 'auto'. If the button is not selectable, it will be grayed out.
Once this button is pressed, the action is immediate. It is not required to press the Apply button for
the action to occur.
Apply - Send the updated screen to the switch and cause the changes to take effect on the switch
but these changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
2011 Fujitsu Technology Solutions
273
©