Fujitsu PRIMERGY BX900 User Manual page 561

10.6.12.3.5 ip name-server
This command specifies the address of one or more domain name servers to use for name-to-address
resolution. There are maximum 6 entries in the Domain Name Server Table.
Syntax
ip name-server <ipaddr>
no ip name-server <ipaddr>
< ipaddr > - IPv4/IPv6 address of the Domain Name Servers.
<no> - Remove the corresponding Domain Name Server entry from the table.
The listed name servers are queried in the specified sequence until a response is received, or
i
the end of the list is reached with no response.
Default Setting
None
Command Mode
Privileged Exec
10.6.12.3.6 ip domain-lookup
This command enables the IP Domain Naming System (DNS)-based host name-to-address translation.
Syntax
ip domain-lookup
no ip domain-lookup
<no> - This command disables the IP Domain Naming System (DNS)-based host name-to-address
translation.
Default Setting
None
Command Mode
Privileged Exec
2011 Fujitsu Technology Solutions
©
559