Fujitsu PRIMERGY BX900 User Manual page 598

10.6.18.5 sflow receiver
Use this command to configure the sFlow collector parameters (owner string, receiver timeout, max
datagram size, IP address, and port).
Syntax
sflow receiver <rcvr_idx> {owner <owner-string> timeout <rcvr_timeout>} | {maxdatagram <size>} | {ip
<ipv4/ipv6>} | {port <port>}
no sflow receiver <rcvr_idx> [ ip | maxdatagram | port ]
<rcvr_idx> - Receiver Index. The range is 1-8.
<owner-string> - The identity string for the receiver, the entity making use of this sFlowRcvrTable
entry. The range is 127 characters. The default is a null string. The empty string indicates that the entry
is currently unclaimed and the receiver configuration is reset to the default values. An entity wishing to
claim an sFlowRcvrTable entry must ensure that the entry is unclaimed before trying to claim it. The
entry is claimed by setting the owner string to a non-null value. The entry must be claimed before
assigning a receiver to a sampler or poller.
<rcvr_timeout> - The time, in seconds, remaining before the sampler or poller is released and stops
sending samples to receiver. A management entity wanting to maintain control of the sampler is
responsible for setting a new value before the old one expires. The allowed range is 0-4294967295
seconds. The default is zero (0).
<size> - The maximum number of data bytes that can be sent in a single sample datagram. The
management entity should set this value to avoid fragmentation of the sFlow datagrams. The allowed
range is 200 to 9116). The default is 1400.
<ipv4/ipv6> - The sFlow receiver IP address. If set to 0.0.0.0, no sFlow datagrams will be sent. The
default is 0.0.0.0.
<port> - The destination Layer4 UDP port for sFlow datagrams. The range is 1-65535. The default is
6343..
no - Use this command to set the sFlow collector parameters back to the defaults.
Default Setting
None
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
596