Lms Ip Net To Media Table - IBM Nways 8260 Manual

Figure 166. LMS IP Net To Media Table
9. If you are planning to use the BOOTP protocol between a BOOTP server and
286
8260 Multiprotocol Intelligent Switching Hub
Config * IP Net To Media Table
System
Port Network Address
1 9.67.46.13
1 9.67.46.33
1 9.67.46.34
1 9.67.46.40
1 9.67.46.41
1 9.67.46.46
Add Entry Search Addr
Add a new entry to the IP Net To Media Table
This table can be used to view and/or modify the contents of the ARP table.
Each entry in this table contains the following parameters:
Network Address
This parameter specifies the IP address of the station that this entry
applies to.
Physical Address
This parameter specifies the MAC address of the station that this entry
applies to.
Type
This field is a read-only field and indicates that the address mapping has
been learned through ARP (dynamic) or configured by the user (static).
To add a static entry to the ARP table, select Add Entry from this panel. A
pop-up menu will be displayed which allows you to enter the IP address and
the corresponding MAC address. Once, you have specified this information
select Set Entry to add the entry to the ARP table or Cancel to abandon the
operation.
client and the BOOTP client is connected to the BOOTP server via the
Multiprotocol Interconnect module, you must configure your module as a
Boothelper .
BOOTP allows a client to request the following from a BOOTP server:
Client s own IP address
IP address of a TFTP server
Name of the code image file
Module: BladeRunner
Page 1 Time:
Media Address Type
400000000001 static
10005A7903C7 dynamic
10005A7903E1 dynamic
0000B528023E dynamic
08008F3003EF dynamic
08005A13396F dynamic
Prev Page
10:50 11 Jan 95
Next Page Exit