Configuring For Routing Functions; Lms Protocols Menu Panel; Custom Filter Statement Table - IBM Nways 8260 Manual

3. Once the you have defined all the entries for all the ports, you must enable

11.8.7 Configuring for Routing Functions

To configure the Multiprotocol Interconnect module for routing, you must select
the Protocols Menu from the Configuration Menu . This panel allows you to
display and modify the configuration parameters relevant to the routing functions
of the Multiprotocol Interconnect module. The Protocols Menu panel is shown in
Figure 160.
Figure 160. LMS Protocols M e n u Panel
278
8260 Multiprotocol Intelligent Switching Hub
Fwd Prio #: Forward the frame at the specified priority (#). # can be
0 to 7. Priority 0 is the highest priority.
Stmt #: Specifies another statement ID from the Custom Filter
Statement Table, so that another test may be applied to the frame. #
can be 1 to 16.
An example of the use of priority is to check for the frame size and assign
higher priority for shorter frames (typically interactive sessions) over the
longer frames (typically batch/file transfer sessions).
An example of a Custom Filter Statement Table entry is shown in Table 40.
Table 40. Custom Filter Statement Table
ID
1
the Custom Filtering option for each port on which you want to apply the
specified test. The Custom Filtering option is specified on the Transparent
Bridging Port Parameters and Source Routing Bridging Port Parameters
panels.
Config *
Return to the previous screen
Test Name Action on Success
802.3 Forward
Protocols Menu
IP
OSPF
DECnet IV
IPX
Exit
Action on Failure
Discard
Module: BladeRunner
Time: 15:17 9 Jan 95