Lms Ospf Neighbors Panel - IBM Nways 8260 Manual

8. Define the other OSPF routers which are neighbors to the Multiprotocol
Figure 176. LMS OSPF Neighbors Panel
298
8260 Multiprotocol Intelligent Switching Hub
Interconnect module. To so so, select OSPF Neighbors from the OSPF Menu
panel. An example of the resulting panel is shown in Figure 176 on
page 298.
Config * OSPF Neighbor Table
System
IP Address Port Router ID
9.67.46.46 0 9.24.104.81
Add Entry
Return to the previous screen
This panel allows you to describe the following parameters for each neighbor
entry:
IP Address
This parameter specifies the IP address of this neighbor.
Port Router ID
This parameter specifies the logical port number of this interface. If this
interface has been assigned an IP address, this parameter will have a
value of 0. If the interface has not been assigned an IP address (a serial
WAN port could be an example) the value of this parameter will be equal
to the logical port number.
Options
This field is read-only. It is a bit mask corresponding to the neighbor s
options parameter. Bit 0, if set, indicates that the area accepts and
operates on external information. If bit 0 is set to zero, it is a Stub Area.
Bit 1, if set, indicates that the system will operate on Type Of Service
metrics other than 0. If set to zero, the neighbor will ignore all metrics
except the TOS 0 metric.
Events
This parameter is read-only and indicates the number of times this
neighbor s relationship has changed state or that an error has occurred.
Retrans QLen
Module: BladeRunner
Page 1 Time:
Options Priority State
0 1 full
Prev Page Next Page
17:45 11 Jan 95
Events Retrans
QLen
4 0
Exit