7.10 8260 Ethernet Modules Summary - IBM Nways 8260 Manual

7.10 8260 Ethernet Modules Summary

The following table provides a summary of the functions supported by the 8260
Ethernet modules.
120
8260 Multiprotocol Intelligent Switching Hub
This command may be used to allow you to monitor the status of the crucial
ports on your network while the alerts from the other ports are disabled.
Set optical power
Each port on this module can be set to operate at high or normal power.
When operating at high power mode, the fiber distance between the two
modules and the module or the transceiver can be as far as 4000 meters.
Please note that you must enable high power mode at both ends to achieve
the maximum possible distance. To set the power mode, you can use the
following management command:
SET PORT {slot.port} HIGH_POWER {enable|disable}
Table 25. 8260 Ethernet Modules Summary
M odule 24-Port 1 0B as e-T
Feature Code 1024
Daughter Cards 1
Supported
I / O M o d u l e s N / A
Number of Ports 24
Type of Ports Telco
S w i t c h i n g Port
Supported
Number of Slots 1
Used
Number 8
B a c k p l a n e
N e t w o r k s
Accessible
Number of 8
Isolated N e t w o r k s
Accessible
Number of A n y C o m b i n a t i o n
Segments of 6
Supported
S i m u l t a n e o u s l y
C a b l i n g UTP Cat 3 and
Supported Above
Security Card Yes - Not on
Support Isolated Networks
Port Redundancy Yes
Network Statistics No
Supported
Without
M o n i t o r i n g Card
Other Notes
10-Port 20-Port 1 0 B a s e - T
1 0 B a s e - F B
1110, 1210, 1610 1020
1 2
N / A N / A
10 20
ST, FC, SMA RJ-45
Port Port
1 1
8 8
4 8
A n y C o m b i n a t i o n A n y C o m b i n a t i o n
of 8
M u l t i - m o d e Fiber UTP & STP
Yes - Not on Yes - Not on
Isolated Networks Isolated Networks
Yes Yes
No Repeater M I B
Fiber supported -
50/125, 62.5/125,
85/125, 100/140
40-Port 1 0 B a s e - T
1040
2
N / A
40
RJ-45
Port
2
8
8
A n y C o m b i n a t i o n
of 8
UTP & STP
Yes - Not on
Isolated Networks
Yes
Repeater M I B