Show Counter For Token_Ring Segments - IBM Nways 8260 Manual

8260A>
8260A> show counter token_ring token_ring_7
Token Ring Statistics for TOKEN_RING_7
-----------------------------------------------------------------------------
Ring Status: No Problems Detected
Ring Open Status: Ring Open
Upstream Station: 40-00-00-03-33-38
Active Monitor Selection Participation:
Line Errors:
Burst Errors:
AC Errors:
Abort Transmitted Errors:
Internal Errors:
Lost Frame Errors:
Receiver Congestion Errors:
Frame Copied Errors:
Token Errors:
Soft Errors:
Hard Errors:
Signal Losses:
Transmit Beacons:
Recoveries:
Lobe Wires:
Removes:
Singles:
8260A>
8260A>
Figure 124. Show Counter for Token_Ring Segments
In the above example, the top portion of the display will always show the
correct information regardless of the settings of the monitoring parameters
for the T-MAC. But, to get the correct counter values (shown in the bottom
part of the display), you must enable DOT5 Group for the T-MAC using the
following command:
SET MODULE {slot.subalot} DOT5_GROUP enable
2. Display network statistics for a token-ring segment
You can display the network statistics for token-ring (DOT5) segments using
the following command:
SHOW COUNTER INTERFACE {token-ring_n | isolated}
Note: These counters are not related to RMON.
An example of the output displayed for this command is shown in Figure 125
on page 224.
Ring State:
Ring Speed:
Functional Addr.: c0-00-00-00-00-18
Disabled
1
7
0
0
0
0
0
0
2
3
0
0
0
0
0
0
3
Chapter 10. 8260 RMON Support
Opened
4 MBPS
223