Show Device Command For Trmm - IBM Nways 8260 Manual

Multiprotocol intelligent switching hub
Table of Contents

Advertisement

TRMM V3.0 allows you to enable/disable the beacon recovery function using the
following command:
SET DEVICE BEACON_RECOVERY {enable|disable}
Note that this feature must be enabled during normal operation; however, you
may disable this feature as a trouble shooting tool, to prevent the ring from
recovering before the faulty device is isolated.
TRMM V3.1 allows you to change the beacon timeout
the TRMM will wait before attempting to unwrap the RI/RO ports after these
ports are wrapped due to a beacon condition) using the following TRMM
command:
SET DEVICE BEACON_TIMEOUT {number of second}
The allowed range for this command is 1 to 100 seconds.
You can display the status of the TRMM beacon_recovery and
beacon_timeout using the following TRMM command:
SHOW DEVICE
An example of the output for this command is shown in Figure 92.
Figure 92. Show Device Command for TRMM
154
8260 Multiprotocol Intelligent Switching Hub
8250> show device
T01MS Token Ring Management Module (Advanced-MGT) v3.10-A pSOS+ SNMP
Name:
8250
Location:
ITSO LAB, Raleigh
For assistance contact:
Mohammad Shabani X2339
Boot EPROM Version: v3.00-A
Flash EPROM Version: v3.10-A
Serial Number: 1088813
Interface IP Address
--------- --------------- -----------
1 *
009.067.046.235 FF.FF.FF.F0
2
009.067.046.235 FF.FF.FF.F0
3
009.067.046.235 FF.FF.FF.F0
4
009.067.046.235 FF.FF.FF.F0
5
009.067.046.235 FF.FF.FF.F0
6
009.067.046.235 FF.FF.FF.F0
7
009.067.046.235 FF.FF.FF.F0
8
009.067.046.235 FF.FF.FF.F0
MAC Address: 10-00-F1-0F-30-B7
Dip Configuration: DISABLED
Trap Receive:
DISABLED
Monitor Contention: ENABLED
8250>
Size: 256 KBytes
Size: 1024 KBytes DRAM Size: 2048 KByte
Restarts: 6
Service Date: 94/09/06
Subnet Mask
Primary Gateway Secondary Gat
--------------- -------------
009.067.046.238* 000.000.000.
009.067.046.238
009.067.046.238
009.067.046.238
009.067.046.238
009.067.046.238
009.067.046.238
009.067.046.238
Diagnostics:
ENABLED
Beacon Recovery: ENABLED
Beacon Timeout: 10 second(s)
the amount of time that
000.000.000.
000.000.000.
000.000.000.
000.000.000.
000.000.000.
000.000.000.
000.000.000.

Advertisement

Table of Contents
loading

Table of Contents