IBM Nways 8260 Manual page 242

220
8260 Multiprotocol Intelligent Switching Hub
SET RMON ALARM ETHERNET {stat_type}.{interface} RISING {threshold}
FALLING {threshold} {event} {time} {trigger} {alarm type}
The following is a summary of the parameters that can be specified for
the Stat_type:
BroadcastPackets
Collisions
CRCAlignErrors
Fragments
Jabbers
MulticastPackets
Octets
OversizePackets
Packets
UndersizePackets
In the above command, event is the index number of the RMON event
that occurs when the threshold is exceeded.
Note: You must issue the above commands for each DMM interface and
for each RMON group that DMM is to collect statistics for. For example,
to enable our DMM to collect RMON Host group for Ethernet_1, we added
interface 3 to the RMON Host control table using the following command:
8260> set rmon host ethernet interface 3
Note
When you enable the probe-function of the DMM, it creates default
control entries for:
Collecting statistics on the MAC interface
Monitoring host information
Monitoring matrix information
Generating two history reports, one every 30 seconds and one
every 30 minutes.
Verify that the appropriate entries in the RMON control tables have been
created. You may do this by displaying the contents of the RMON
control tables using the following command:
SHOW RMON {rmon_group} CONTROL ALL
In the above command, the
Alarm
Event
History
Host
Matrix
TopN_hosts
rmon_group can be: