Configuring The Dmm; D M M Interface Configuration Quick Reference; Dmm Terminal Defaults And Options - IBM Nways 8260 Manual

proper modem operation. See 4.2.4.3, "Configuring Terminal Settings for DMM"
on page 47 for description of Set Terminal Hangup command.

4.2.4 Configuring the DMM

The following table is a quick reference to the tasks required to configure the
DMM interface.
Before your terminal and the DMM can communicate you must set up the
terminal parameters to match the DMM settings. The factory defaults and
options for the DMM are listed in Table 10. Initially the terminal must match the
defaults.
Table 9. DMM Interface Configuration Quick Reference
Procedure
Configure the terminal to match default
DMM settings
Configure DMM users
Configure DMM terminal settings
Hub configuration
Device configuration
IP configuration
SNMP configuration
Table 10 (Page 1 of 2). DMM Terminal Defaults and Options
Parameter Factory
Default
Baud 9600
Data bits 8
Parity None
Command
Refer to the documentation provided
with the terminal
SET LOGIN USER
SET LOGIN ADMINISTRATOR
SET LOGIN SUPERUSER
SET LOGIN PASSWORD
SET LOGIN ACCESS
SET TERMINAL CONSOLE
SET TERMINAL AUXILIARY
SET TERMINAL PROMPT
SET TERMINAL TIMEOUT
SET CLOCK
SET DEVICE NAME
SET DEVICE LOCATION
SET DEVICE CONATCT
SET DEVICE DIAGNOSTICS
SET DEVICE MAC_ADDR_ORDER
SET DEVICE RESET_MASTERSHIP
SET DEVICE DIP_CONFIGURATION
SET DEVICE TRAP_RECEIVER
SET IP IP_ADDRESS
SET IP DEFAULT_GATEWAY
SET IP SUBNET_MASK
SET IP ACTIVE_DEFAULT_GATEWAY
SET COMMUNITY
SET ALERT AUTHENTICATION
SET ALERT CHANGE
SET ALERT CONSOLE_DISPLAY
SET ALERT HELLO
SET ALERT PORT_UP_DOWN
SET ALERT SCRIPT
Options
300,1200,2400,4800,9600,19200,38400
7 or 8
Odd, Even or None
Chapter 4. 8260 Distributed Management Architecture
43