Show Counter Command For Ethernet Networks; Show Counter Ethernet - IBM Nways 8260 Manual

10.6.3 SHOW COUNTER Command for Ethernet Networks

This DMM command allows you to display the following information for the
segments to which the DMM has an interface via an E-MAC:
1. Display error statistics for an Ethernet segment
Figure 118. Show Counter Ethernet
2. Display network statistics for an Ethernet segment
Note
The statistics that are collected using the DMM commands described in the
next sections are NOT all RMON statistics. The non-RMON statistics are
identified.
You can display the error statistics for Ethernet segments using the following
command:
SHOW COUNTER ETHERNET {ethernet_n | isolated}
Note: These counters are not related to RMON.
An example of the output displayed for this command is shown in
Figure 118.
8260A> show counter ethernet ethernet_1
Ethernet Statistics for ETHERNET_1
-----------------------------------------------------------------------------
FCS Errors
SQE Test Errors
Alignment Errors
Carrier Sense Errors
Frame Too Longs
Deferred Transmissions
Late Collisions
Excessive Collisions
Single Collision Frames
Multiple Collision Frames
Internal MAC Receive Errors
Internal MAC Transmit Errors
8260A>
You can display the network statistics for Ethernet segments using the
following command:
SHOW COUNTER INTERFACE {ethernet_n | isolated}
Note: These counters are not related to RMON.
An example of the output displayed for this command is shown in
Figure 118.
0
0
0
0
0
0
0
0
0
0
0
0
Chapter 10. 8260 RMON Support
215