Port Active Per-Port Switching Module Side View; Port Active Per-Port Switching Module Led Descriptions - IBM Nways 8260 Manual

Figure 109 shows the side view of the 18-port active per-port switching module.
As can be seen, in addition to the 11 isolated segments and the mounting for
one T-MAC, there is an 8-position DIP switch located on the module. These DIP
switches are used in the absence of an installed management module in the
8260. However, if a management module is installed in your 8260, the setting of
these DIP switches will be ignored unless DIP_CONFIGURATION is enabled for
DMM. For more information, please refer to 4.2.4.4, " Configuring DMM Device"
on page 50.
Figure 109. 18-Port Active Per-Port Switching Module Side View
176
8260 Multiprotocol Intelligent Switching Hub
Table 28. 18-Port Active Per-Port Switching Module LED Descriptions
LED Name
Module Status Green
RI/RO Green
JA Green
Port Status Green
RI/RO Green
Color State
On
Off
Blinking
On
Off
Blinking
On
Off
Blinking
On
Off
1 blink
On
Off
Description
Module powered up OK
No Power
Module failed self diagnostics
Trunk enabled and operating
Trunk disabled
Trunk enabled but not
operating normally
JADC card installed and
operating normally
JADC card not installed
JADC card failed diagnostics
Port enabled and operating
normally on the ring
Port disabled
Port enabled, no phantom
Ports 17 and 18 are RI/RO
ports
Ports 17 and 18 are lobe ports