Lms Configuration Panel - IBM Nways 8260 Manual

Config * OSPF Static Convert Table
System
IP Address
Modify Entry
Figure 181. LMS Configuration Panel
This panel allows you to enter the following parameters for each entry:
IP Address
This parameter specifies the destination IP address.
IP Mask
This parameter specifies the destination IP address mask.
TOS
This parameter specifies the Type Of Service for this route.
Hop Count
This parameter specifies hop count for this static route.
Metric
This parameter specifies the metric in OSPF converted from static route.
14. If you have not defined the conversion information for an imported static
route, the Static Default Conversion Table will be used. This table is set with
a number of default entries when the Multiprotocol Interconnect module is
shipped. You can view and/or modify the contents of this table by selecting
OSPF Static Default Convert Table from the OSPF Menu panel. The resulting
display is shown in Figure 182 on page 304.
Page 1
IP Mask TOS
Prev Page
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 17:48 11 Jan 95
Hop Metric
Next Page Exit
303