Output From Show Terminal Command - IBM Nways 8260 Manual

You can display the current settings for console and auxiliary port using the
following command:
8260> show terminal
An example of the output displayed by this command is shown in Figure 22.
Figure 22. Output from Show Terminal Command
4.2.4.4
The following commands are used to allow you to configure the DMM:
50
8260 Multiprotocol Intelligent Switching Hub
This option is very useful in identifying the DMM to which you are logged in.
The default prompt is
for both the terminal prompt and the DMM device name. See 4.2.4.4, "
Configuring DMM Device" on page 50 for how to configure DMM device
name.
Set Terminal Timeout
This command is used to specify the amount of time the terminal will remain
active during the absence of keyboard activity. This command is used for
security, to ensure that an unattended DMM console will not remain logged
in for long periods. The default is
timeout. An example of this command is as follows:
8260A> set terminal timeout 10
Note that the value specified in the above command is in minutes.
Terminal Session Parameters:
Prompt: 8260A>
Timeout time: 0
Console Port Parameters:
Baud: 9600
Data bits: 8
Parity: NONE
Stop bits: 2
Hangup: ENABLED
Mode: COMMAND LINE
Terminal: VT100
Auxiliary Port Parameters:
Baud: 9600
Data bits: 8
Parity: NONE
Stop bits: 2
Hangup: DISABLED
Mode: SLIP
Terminal: VT100
8260>
Configuring DMM Device
Set Clock
This command allows you to set the time, day and date for the DMM. The
following is an example of using this command:
8260> set clock 15:45 95/1/19 Thursday
It is recommended that you use the same ID
which means the terminal will never
Destination IP Address: 9.67.46.3